2003 jeep liberty oil pump replacement

What is an oil pump?

The oil pump is a vital engine component that delivers pressurized oil to critical internal engine components.

How does the oil pump work?

Engine oil is kept in the engine oil pan on most engines, and an external oil reservoir on many high performance engines. In either case, the oil pump is responsible for pumping oil into the engine faster than the engine can use the oil. This creates a constant pressure as the oil is pushed through oil passages. The oil passages use targeted outlets to send oil to precise locations which need protection. Oil is less of a lubricant, and more of a barrier, as it prevents metal contact between internal engine components. When that barrier is weak, metal contact will occur at an increasing rate, relative to the rate of oil pressure degradation. The barrier the oil creates is weakened or completely compromised without oil pressure. Oil pressure forces oil into the tight areas as fast as the oil is used. This means, when the oil pump fails, engine components will run out of oil, and damage will occur.

What are the symptoms related to a bad oil pump?

When the engine oil pump fails, the fuel pressure sensor will send a signal to the computer, signaling low oil pressure. This causes the engine's computer to illuminate the check engine light, and store on-board diagnostic (OBD) trouble codes which reflect the oil pressure readings at the sensor. Also, the engine may be placed in reduced power mode for engine protection, but in most cases, the engine will stall, and fail to restart.

Can I drive with a oil pump problem?

When the engine oil pump fails, the vehicle can not be driven. The engine may restart if it was turned off before damage was done, but will only run for a moment before the engine fails completely. No matter how much oil is in an engine, the engine cannot run without the oil pump creating pressure.

How often do oil pumps need to be replaced?

Engine oil pumps may fail after a few thousand miles, but most often they last the lifetime of the vehicle. Most vehicles will never have an issue with the oil pump, and changing engine oil and engine oil filter on time will help prevent premature failure.

How many hours does it take to replace an oil pump?

In most cases, you'll also need a new oil pan gasket and gaskets for the front of your engine. If you take your car into a shop to replace the oil pump, you're looking at $300 to $2,500. Depending on how much work needs to be done, it can take 4 to 8 hours to replace the oil pump.

Can I replace oil pump myself?

Unfortunately, signs are pointing to an oil pump replacement — and the sooner, the better. Fortunately, parts are affordable, it's a straightforward task if you have some time, and the DIY method can save you hundreds of dollars.

How do I know if my oil pump is failing?

A look at the three main signs that you need to fix or change your oil pump: low oil pressure, high engine temperature, and noise..
Low oil pressure. A bad oil pump will lose the ability to properly pump oil through your system. ... .
Increased engine operating temperature. ... .
Noise..

Toplist

Latest post

TAGs