Black and decker lithium hand vacuum replacement charger

Q: Where is the model number on a Black and Decker hand vacuum?

A products model number will be on the box, owners manual, or on the bottom or back of the product.

Table of Contents Show

How do you charge a Black and Decker lithium vacuum?
Where is the model number on a Black and Decker hand vacuum?
Why is my Black and Decker handheld vacuum not charging?

Local store prices may vary from those displayed. Products shown as available are normally stocked but inventory levels cannot be guaranteed

For screen reader problems with this website, please call 1-800-430-3376 or text 38698 (standard carrier rates apply to texts)

Privacy & Security Statement
Cookie Usage
My Preference Center
California Privacy Rights & Report
Do Not Sell My Personal Information
California Supply Chain Act
Site Map
Store Directory
Mobile Site
Responsible Disclosure

To take off the nozzle, filter, and catch bowl first start off by pushing in the button identified with a red square and twist that part of the device toward the handle portion of the vacuum and it should click and pop off the chassis.

Once the nozzle, filter and dust bowl have been removed each part can be removed from the nozzle section of the device.

Remove the three screws.

Flip the hand vac over and remove two screws.

Once you have successfully unscrewed the five screws holding the cover on you should be able to take the cover off.
Remove the L-shaped plastic hook.
Once the L shaped hook has been removed the motor will easily fall out of place.

Once the motor has been removed from its home the two wires that are giving it power can easily be removed by pulling on them carefully.
This will then allow for you to replace the motor.

Remove the three screws.

Remove the battery.

To get to the charging port you will need the plastic opening tool.
Remove the three screws on the handle of the vacuum.

Use a plastic opening tool to separate the two pieces of plastic.

Remove the plastic covering to the port.
Remove the wires to replace the charging port.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Team

How do you charge a Black and Decker lithium vacuum?

Plug the charger directly into an electrical outlet. Use the charger only in a standard electrical outlet (120V/60Hz). Unplug the charger from outlet before any routine cleaning or maintenance.

Where is the model number on a Black and Decker hand vacuum?

A product's model number will be on the box, owner's manual, or on the bottom or back of the product.

Why is my Black and Decker handheld vacuum not charging?

Check the charging cord to make sure it is not damaged and it is correctly attached to the charging base. Make sure the switch is in the Off or "O" position. If the charger is working properly it will be warm to the touch. Make sure you have charged the unit for a minimum of 16 hours pre-November 2014.