Related Hot News
How to program your Audi Flip Key Fob I have done a ton of searching and found how to accurately program a key fob on the forums. The problem with all the directions that I had found was that once I programmed one key fob, the others would erase. None of the directions showed all the steps to program more than one key correctly without losing the others (which most people will have). This DIY has the correct programing procedure no matter how many fobs you have. For some reason if you pull your battery or you change the battery in your fob you might be finding a situation where you need to do this programming. There are two kinds of programming. If you have remotes that have been programmed to the car previously the steps are easy. There are longer steps if the keys are new and those are the secondary ones. Steps to reprogram keys to a car they are already linked to: Do this for each remote. Relink to seat positions (press and hold mem position #, then unlock button for 2 seconds and release both) and done. To program new remotes on a car never linked to previously: 1. Take a key (valet key works best, put it into the ignition and turn the key to the
"on" position, so the dashboard lights come on. ***If you have only one key skip to step 16. Otherwise continue to step 7.*** 7. Lock the door again (physically) with the key, (not the remote) by turning clockwise. ***If you have three keys proceed to step 10. Otherwise skip to step 16.*** 10. Lock the door again (physically) with the key, (not the remote) by turning clockwise. ***If you have four keys proceed to step 13. Otherwise skip to step 16.*** 13. Lock the door again (physically) with the key, (not the remote) by turning clockwise. 16. Remove the key from the ignition. Make sure that to test the newly program remotes, the original key is removed from the ignition since this exits the programming process. Someone might be a bit frustrated trying to test it with it still in 'program' mode. I had some diffuculty accessing the programming mode. If it doesnt work then take the key out of the ignition and start over. Rinse lather repeat. It will go eventually. How do I program my Audi smart key?Answer provided by. Press the unlock button on your key fob and hold it down.. While you hold down the unlock button, insert the key into ignition position II (ON).. Continue to hold down the unlock button for three seconds and then remove the key from the ignition. And, voilá—your key fob should be ready to go!. |