2011 ford fusion power steering control module location

One of the most common failure modes for the Ford Fusion is connected to the DTC U3000 (including U3000:46 and U3000:96). The Ford Fusion 2011-2012 has also been recalled for ECU failure. In this article, we'll list the symptoms, diagnoses, and solutions related to Ford Fusion vehicles that generate the U3000 error code.

U3000 Error Code Symptoms

The U3000 error code is related to difficult steering conditions that may be reported by the owner/driver. Symptoms of this failure mode include the loss of power steering, making the steering wheel incredibly hard to turn (similar to old-fashioned mechanical steering without power assist). The car can be steered, but because the electric motor assembled in the rack is not working, effort on the wheel will increase significantly. Additionally, a steering indicator light may illuminate on the dashboard. This failure mode will usually appear upon starting the vehicle, not while driving or idling.

Diagnosing and Repairing Ford Fusion with DTC U3000

DTC U3000 in the Ford Fusion can be caused by a few different issues, including:

  • Steering gear internal failure
  • Incorrect EPAS gear installed
  • Ice/frost buildup on relay contacts
  • Disconnected, or cut electrical wiring and/or connectors
  • Disconnected or broken system ground

If you're reading a U3000 error code on a Ford Fusion, you can follow a few best practices to service the issue. If the code will not erase, the power steering system will most likely need to be replaced or rebuilt. However, if the vehicle is also throwing other error codes, there may be an issue with a different system that is no longer providing information to the steering rack, causing the U3000 code to trigger. Before you rebuild the steering, you should diagnose the vehicle for any other system failures. If the ECU is blocked, the steering system will need to be replaced.

Additionally, service technicians should be aware that a recall has been issued for 2011-2012 Ford Fusion vehicles without a 3.5L engine because their electronic power steering assist systems may shut down due to a steering motor sensor fault. Newer gen Ford Fusions were installed with an updated ECU that improved upon this programming error. Fusions that meet these specifications that return the U3000 error code may be part of this recall.

The 2011 Ford Fusion does have power steering sensors. Having great steering is important for changing lanes and moving about on the road. You will eventually come across some problems though. Steering fluid can leak at one point. It may turn to one side. The steering wheel can become stuck. The strut bearings could become bad. The rack mount could become faulty. The steering pump might become loose and that will be disaster for Your vehicle. The power steering fluid needs to be replaced every 75,000 miles. Along with changing fluids, You will hear noises from steering parts. A faulty bearing will make a nasty sound. A loose bearing will become irritable to the ear.

accountCircle

Thomas H. August 29, 2019

The 2011 Ford Fusion has digital electronic power assisted steering - EPAS - which monitors the Power Steering Control Module (PSCM) which senses steering effort, Electronic Control Unit (ECU), and a Torque Sensor and Steering Wheel Position Sensor. There was a recall on the units due to periodic loss of power that switched drivers to manual steering.

The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com does not research or authenticate any of the Answers provided.

2010 Ford Fusion Module Locations

2011 ford fusion power steering control module location

Ford body control module

programmed by the rebuilder. Due to the requirement to program a control module to your exact VIN, it’s just not a good to buy a junk yard module over a rebuilt unit. Simply perform a search for a rebuilder near you and contact them for pricing and programming abilities.

Find lots of other information for your Ford Vehicle.
To find fuse diagrams, click here
To find Relay locations, click here
To find Sensor Locations, click here
To find Module Locations, click here
To find Switch Locations, click here
To find Firing Order, click here

2010 Ford Fusion Module Locations,  2010 Mercury Milan Module Locations, 2010 Lincoln MKZ Module Locations

ABS Control Module (2.5) Right front of engine compartment.  

ABS Control Module (3.0L) Right front of engine compartment.  

ABS Control Module (3.5L) Right front of engine compartment.  

Ambient Lighting Module Front of center console.  

Antenna Module Right rear of trunk.  

Audio Control Module (ACM) Center of dash.  

Audio Digital Signal Processing (DSP) Module Right front of trunk.  

Blower Motor Speed Control Right side of HVAC housing.  

Driver Door Module Front of driver’s door.  

Driver Seat Module (DSM) Under driver’s seat.  

Dual Climate Controlled Seat Module (DCSM) Under right front seat cushion.  

Electronic Throttle Control (ETC) Module (2.5L) On throttle body.  

Electronic Throttle Control (ETC) Module (3.0L) On throttle body.  

Electronic Throttle Control (ETC) Module (3.5L) On throttle body.  

Front Control Interface Module (FCIM) Center of dash.  

Front Display Interface Module (FDIM) Center of dash.  

Fuel Pump Control Module Left rear side of vehicle.  

Global Positioning Satellite Module (GPSM) Left side of dash.  

Headlamp Control Module Left rear of engine compartment.  

Heated Seat Module Under seat bottom.  

HVAC-DATC Center of dash.  

HVAC-EMTC Center of dash.  

Occupant Classification Module (OCSM) Under right front seat cushion.  

Parking Aid Module (Fusion) Left rear trunk.  

Parking Aid Module (Milan) Left rear of trunk.  

Parking Aid Module (MKZ) Left rear of trunk.  

Power Steering Control Module (PSCM) (2.5L) Right side of engine compartment, near strut tower.

Power Steering Control Module (PSCM) (3.0L) Right side of engine compartment, near strut tower.

Power Steering Control Module (PSCM) (3.5L) Right side of engine compartment, near strut tower.

Powertrain Control Module (PCM) (2.5L) Left rear of engine compartment.  

Powertrain Control Module (PCM) (3.0L) Left rear of engine compartment.  

Powertrain Control Module (PCM) (3.5L) Left rear of engine compartment.  

Restraints Control Module (RCM) Under center console.  

Roof Opening Panel Module Front of roof.  

Side Air Curtain Module (Driver) Base of left “C” pillar.  

Side Air Curtain Module (Passenger) Base of right “C” pillar.  

Side Thorax Air Bag Module (Driver) Left side of seat back.  

Side Thorax Air Bag Module (Passenger) Right side of seat back.  

Windshield Wiper Module Left side of dash.  

4×4 Control Module Left side of dash.

Transaxle Control Module (AW21) On transaxle.  

Transmission Control Module (FNR5) Under instrument panel, LH side.  

Posted on September 17, 2018 by Rick Muscoplat

Where is power steering control module located?

Also, be aware that most power steering control modules will likely be mounted on or near the steering column or the steering gear.

Where is the power steering fuse on a 2011 Ford Fusion?

The fuse panel is located under the instrument panel to the left of the steering column.

How do you change a power steering control module?

Step 1: Disconnect the vehicle's battery. ... .
Step 2: Remove the steering column from the steering box. ... .
Step 3: Remove the steering column covers. ... .
Step 4: Remove the steering wheel. ... .
Step 5: Remove the dashboard. ... .
Step 7: Remove the electrical harness from the power steering control unit..

Does a 2011 Ford Fusion have a power steering reservoir?

The power steering on a 2011 Ford Fusion 4 cylinder does not have power steering fluid/reservoir, it has fuses.